Configure BladeRunner

When you start BladeRunner, you can set a logging level to control. By default, BladeRunner writes basic informational messages to standard output. You can have more detailed messages written by adding the --verbose or --debug (most detailed) flags as shown below:

Within the BladeRunner installation directory, navigate to the conf directory. Within this directory, open the file bladerunner.conf in a text editor.

Locate the property jettyPort, and edit the port number as required.

Within the BladeRunner installation directory, navigate to the conf directory. Within this directory, open the file bladerunner.conf in a text editor.

Locate the property defaultInputEncoding, and edit the default encoding as required.

Within the BladeRunner installation directory, navigate to the conf directory. Within this directory, open the file bladerunner.conf in a text editor.

Locate the minifiers section. This contains a list of available minification (compression) levels for when you produce your war file. To generate a war file that is compressed using Google Closure "simple minification", use the following command:

Within the BladeRunner installation directory, navigate to the conf directory. Within this directory, open the file test-runner.conf in a text editor.

Follow the instructions in this file to specify the configuration for the js-test-driver server and the browsers that are used when you run tests.

Within the BladeRunner installation directory, navigate to the conf directory. Within this directory, open the file users.properties in a text editor.

Within this file you will find Caplin Trader user credentials.